LACP between a Cisco enterprise switch and Meraki MS switch

dbauman
New here

LACP between a Cisco enterprise switch and Meraki MS switch

Greetings,

 

Any documents out there on configuration for LACP between a Cisco enterprise switch and Meraki MS?  More importantly, the Cisco side.  I know how to do Cisco  to Cisco and Meraki to Meraki, but cannot seem to get Cisco to Meraki to work properly.

3 REPLIES 3
ww
Kind of a big deal
Kind of a big deal
PhilipDAth
Kind of a big deal
Kind of a big deal

GIdenJoe
Kind of a big deal
Kind of a big deal

The Meraki switches run LACP mode active with slow timers.

So normally if you configure mode active or mode passive on your Catalysts and don't change the timers you should have a succesful connection.

 

If you are doing MEC (etherchannel on 2 stacked Meraki switches) make sure their stacking config is working.

Else you will get two different actor ID's and the bundle will fail.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels