Inter VLAN MS250

nst1
Building a reputation

Inter VLAN MS250

I have an MS250-24P and it is the only device in my Network.

in the configure 4 different VLANs, try to do a test from the Tools tab of the MS pinging between VLAN but it was not possible to show me "Loss rate: 100%, Average latency: N / A"

 

where can I configure Inter VLAN ??

7 Replies 7
NolanHerring
Kind of a big deal

Did you create L3 SVI's on that switch for each of those VLANs?
Nolan Herring | nolanwifi.com
TwitterLinkedIn
nst1
Building a reputation

Yes, for example 

 

10.130.156.0/24    10.130.156.1

150.130.170.0/24  10.130.170.1

150.130.190.0/24   10.130.190.254

NolanHerring
Kind of a big deal

Oh wait....are you trying to ping the SVI from the same switch they live on? I don't think that will work. Try doing it from another switch that connects to this 'core' if you can.

I just tried it on a switch, it is unable to ping itself.
Nolan Herring | nolanwifi.com
TwitterLinkedIn
nst1
Building a reputation


@NolanHerring
Ok, I just have that switch, I could not do what you say.

But if I have two computers connected in the same swicth with different VLAN should I ping without any problem correct ???
NolanHerring
Kind of a big deal

They should yes
Nolan Herring | nolanwifi.com
TwitterLinkedIn
kYutobi
Kind of a big deal

Is your trunk port allowing all VLANs? You're saying that you have a MS250 do you have anything else in the equation? Other switches etc?

Enthusiast
DN
Here to help

Unless you have some policy added to deny communication between the Vlans , pinging from one PC to another should go through . Let us know once you tried 🙂 .

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels