cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

High Rate of STP Topology Changes

Just browsing

High Rate of STP Topology Changes

I get "High Rate of STP Topology Changes" on all of my Meraki Core switchports that are connected to other non-Meraki switches. Should I be concerned and what would be my next steps in troubleshooting this? 

3 REPLIES 3
Head in the Cloud

Re: High Rate of STP Topology Changes

I'd, first of all, understand your STP topology and then work backwards from there. Do you have the Layer 2/STP topology diagramed/documented at all?
Eliot F | Simplifying IT with Cloud Solutions
Found this helpful? Give me some Kudos! (click on the little up-arrow below)
Meraki Employee

Re: High Rate of STP Topology Changes

Agreed, I'd confirm all of the physical connectivity and do some quick packet captures or work with Support to find the source(s) of the TCN BPDUs and start from there, possibly even temporarily admin-downing certain redundant/blocking links to isolate the issue.

Highlighted
Kind of a big deal

Re: High Rate of STP Topology Changes

Have you configured the root priority for the switch that should be the core of your network?

https://documentation.meraki.com/MS/Other_Topics/Switch_Settings#Setting_the_STP_Root_Bridge

 

Next the other switches, what are they?  If they are Cisco Enterprise switches I would configure them to use mst "spanning-tree mode mst".

If they are dumb layer 2 switches it is possible they don't even run spanning tree.

 

Look for links between edge/leaf switches that should be there.  You ideally want a loop free design where the downstream switches only connect to the core switch and no other switches.

Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.