GLC-BX-D= and GLC-BX-U= on MS1210

[Ulfen]

Hi

Will the following SFP modules work with MS210?

If you use the matrix tool these modueles are not listed. They are listed under 9300. There is no C9300-M category in this tool.

Nor are they listed under MS210 and C9300-M datasheets on the Meraki.com website.

I imagine that they should work even if not listed anywhere.

[cmr]

BiDi transceivers are not supported on Meraki devices, though they may work...

[GIdenJoe]

Meraki Engineer says on the native MS switches (MS1x, MS2x, MS3x, MS4x they would not work.

On all Catalyst switches (c9300-m, MS390) they should work just fine.

[Ulfen]

OK thanks. It means you got this from Meraki engineer directly? 

[GIdenJoe · Accepted solution]

It was in enquiry I made to our AM at Meraki London who then forwarded it to an engineer internally.

I had a customer with several networking closets but only 3 pairs of fiber to each while having cascaded fiber links.  So I had to look for a solution to get all access switches directly connected to distribution and still having a spare pair here and there.  So I had to change the solution to C9300L stacks and some C9200CX compact switches that are in Meraki monitoring mode to get this to work.

[cmr]

@Ulfen I think the pertinent word is 'should'.