Hi All,
Just need to get some advice regarding this issue, after the Meraki stacks were installed.
The Palo alto started getting flow_rcv_dot1q_tag_err from the same VLAN and Client.
I checked the dashboard and it shows the following
Possibly spanning tree related?
What can Cause flow_rcv_dot1q_tag_err errors? - Knowledge Base - Palo Alto Networks
What is the old switchport config in comparison to the Meraki switchport config?
The configuration is as follows for both ports.
interface GE0/x
description 32-063
switchport access vlan 464
switchport mode access
switchport voice vlan 600
spanning-tree portfast
Previously the load-balancer VLAN is using 464, on the new meraki, it is now using 404
This is the config in Meraki
Stack 2 Port 48
Stack 5 Port 47
This was really the port configured towards the PA ? Odd seeing a voice vlan configured.
Hi, the uplink to PA is this port.
Hi All,
Will this cause the issue?