Changing an MS Template

sambo
Getting noticed

Changing an MS Template

We removed a single network from the global template due to a slight SSID change.

I now want to bind this network back into the global template.

This is very simple I just add this network back into the binding....

But will there be any outage?

Sam

6 Replies 6
MarcP
Kind of a big deal
sambo
Getting noticed

Great document that I'd not seen but it doesn't talk about any outage for changes etc. The only changes that are in the new binded template will be an SSID that was not being broadcast before. But I didn't know if this would cause any outage during the template change for config checks or anything.

MarcP
Kind of a big deal

Haven´t done this yet, so I´m not sure. Would imagine it may interrupt for a short period of time, but someone else can probably give you more verified information.
Do you maybe have a testlab where you can figure this out?

 

BTW, understood it like you want to bind it to the old template again, which seem to cause in a problem.

sambo
Getting noticed

Not the same template a different template. Just a straight swop. I'm doing it at 6pm so I'll let you know!

 

MarcP
Kind of a big deal

Did it work?

sambo
Getting noticed

I did it last night. I re-binded the template and there was no loss of service.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels