Camera Zones

thecameraman
New here

Camera Zones

Hi Meraki community,

 

I have two MV32 cameras (5.0) configured with motion-based retention with an always recording schedule.

 

Areas of interest are enabled covering most of the entire view of each camera.

 

Q. When I create a zone and select a particular area with 100% detection overlap and then hit save, the dashboard saves a completely different area to the one I selected.

 

Any idea why this happens? I've tried in different browsers and still the same issue.

 

Thanks,

 

1 Reply 1
Ryan_Miles
Meraki Employee
Meraki Employee

I believe it's a known/open bug. Please open a Support case so they can confirm and attach your issue to it.

Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.