Cloning Configuration?

[brennanc01]

Hi,

Sorry if this is a foolish question, but is there any way to clone the configuration set on the sensors across networks? 

Best regards,

Ciaran

[double_virgule]

You could use the Configuration Sync. 

https://documentation.meraki.com/General_Administration/Organizations_and_Networks/Cloning_Networks_...

[pdeleuw]

Config Sync only applies to MR and MX networks, not to MT networks.

[double_virgule]

Thanks for the clarification!

[brennanc01 · Accepted solution]

Thanks all, appears there isn't currently a smooth way of doing this.

[BDillon]

We fell victim to this issue when we setup 150 MT10 sensors across 72 networks.
Its all done individually per network. Including alerts etc.
=( 

[pdeleuw]

Maybe the API is your friend.

[BDillon]

I delved into that, I couldn't get it to work having been on it for a couple of hours, it was just as quick to do it all manually.
Any pointers - if you have it working would be appreciated.
Although doing it manually allowed me to rename the device, and drop it on the Mapped Network floor plans. 

[pdeleuw]

Sorry, I did not do something like this via API. I think the API is a good thing for doing the same job a lot of times. but of course, if setting up the API requests is more time consuming than doing it manually, it is better to do it manually.