WAN connection Issue

kuni
Getting noticed

WAN connection Issue

We have MPLS and Internet line.

So, I'd like to do setting on MX.

But because of IP issue, I have to set MS device in front of WANs.

I'd like to know whether this is working well or not.

Please refer the below connection.

 

MRs---MS C---MX---MS A ---Internet

                             ---MS B ---MPLS

 

In case of MX, I will set load balancing.

Thank you,

 

Waiting for your good solutions.

 

3 REPLIES 3
Nash
Kind of a big deal

Re: WAN connection Issue

How do you want the data to flow on the MPLS line?

 

Are you using it as a secondary WAN, or is it for private traffic only?

 

In terms of putting a switch in front of the MX, so long as you've got your VLANs setup, that's fine. I've got a client where we're splitting an ISP between multiple firewalls, so we setup a vlan for switchports in use with that ISP.

jdsilva
Kind of a big deal

Re: WAN connection Issue

If you're connecting the MPLS to a WAN port keep in mind the MX requires Internet access on WAN ports. If you have private MPLS connected to a WAN port things may not work the way you expect them to. 

 

 

kuni
Getting noticed

Re: WAN connection Issue

Thank you for your comment.

 

I'd like to use the traffic both of them.

In case of internet traffic will connect site-to-stie VPN.

Please refer the below information.

 

MRs---MS C---MX---MS A --------------Internet---MX

                             ---MS B --- Router ---MPLS---Router

 

I know Meraki can't control mpls protocol directly so I will install router in front of Meraki device.

 

In this case, should ISP set vlan for Meraki MS ?

 

Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.