WAN connection Issue

[kuni]

We have MPLS and Internet line.

So, I'd like to do setting on MX.

But because of IP issue, I have to set MS device in front of WANs.

I'd like to know whether this is working well or not.

Please refer the below connection.

MRs---MS C---MX---MS A ---Internet

                             ---MS B ---MPLS

In case of MX, I will set load balancing.

Thank you,

Waiting for your good solutions.

[Nash]

How do you want the data to flow on the MPLS line?

Are you using it as a secondary WAN, or is it for private traffic only?

In terms of putting a switch in front of the MX, so long as you've got your VLANs setup, that's fine. I've got a client where we're splitting an ISP between multiple firewalls, so we setup a vlan for switchports in use with that ISP.

[kuni]

Thank you for your comment.

I'd like to use the traffic both of them.

In case of internet traffic will connect site-to-stie VPN.

Please refer the below information.

MRs---MS C---MX---MS A --------------Internet---MX

                             ---MS B --- Router ---MPLS---Router

I know Meraki can't control mpls protocol directly so I will install router in front of Meraki device.

In this case, should ISP set vlan for Meraki MS ?

[jdsilva]

If you're connecting the MPLS to a WAN port keep in mind the MX requires Internet access on WAN ports. If you have private MPLS connected to a WAN port things may not work the way you expect them to.