Hello all,
I need help assigning VLANs from my Meraki MX84 to our SG350X switches. Here is what I have setup:
VLAN 1: 172.30.0.0/21 MX IP 172.30.7.254
VLAN 3: 10.0.8.0/24 MX IP 10.0.8.254
Per-Port VLAN Settings: Port 3 (Trunk) Native VLAN1 (Default) w/ All VLANS allowed. Port 6 (trunk) is setup for VLAN3, when I connect my computer to it directly everything works and I get an IP under the 10.0.8.x range.
Next I went to my Cisco SG350X and created a new VLAN:
![Screen Shot 2021-06-05 at 6.48.45 AM.png Screen Shot 2021-06-05 at 6.48.45 AM.png](https://community.meraki.com/t5/image/serverpage/image-id/18478iAEC3FA7C4786E3B3/image-size/medium?v=v2&px=400)
And an additional static IP for VLAN 3 (10.0.8.1 w/ mask 255.255.255.0).
![Screen Shot 2021-06-05 at 6.48.37 AM.png Screen Shot 2021-06-05 at 6.48.37 AM.png](https://community.meraki.com/t5/image/serverpage/image-id/18477i94B5394403B0E036/image-size/medium?v=v2&px=400)
I then went to the Port to VLAN settings and set Port 5 to Untagged.
![Screen Shot 2021-06-05 at 6.51.32 AM.png Screen Shot 2021-06-05 at 6.51.32 AM.png](https://community.meraki.com/t5/image/serverpage/image-id/18479i6398FED8B856EE78/image-size/medium?v=v2&px=400)
After doing all of that I connected directly to that port and after about a minute I get an APIPA IP. I can't figure out what's going wrong. I can ping my MX gateway 10.0.8.254, but I get 100% packet failure when I ping the VLAN static IP on the switch 10.0.8.1.
I'm new at the networking side of things (currently working on A+, Networks + certs). Any insight would be greatly appreciated!