Hi there, just a quick question and a couple thoughts I've been having. I have two internet connections coming into our MX64. One is Comcast Business Deluxe 100+ which is 100 down and 20 up, and a secondary backup TDS dsl connection at 3 down and >1 up. My question is about specifiying the values in the load balancing area of the MX64 config console.
I can use speedtest.net and sometimes get close to 115 down and 24 up, and so I was wondering about setting values in the load balancing that are higher than speeds purchased. I wouldn't want to lose a little bandwith simply because I set the limits too low, ya know? But are there perhaps negative consequences from setting values slightly above purchased numbers or speedtest numbers?
@CharlesIsWorkin You have described two different features in your question so its a little confusing, you mentioned the ADSL isa backup connection and then later on you mentioned load balancing.
IMHO load balancing with a ADSL connection would be a waste of time, usually load balancing uses either a spill over, ratio or round robin configuration. Load balancing is usually used in cases of multiple high speed WAN connections and large volumes of traffic. The idea is that your primary WAN isn't being saturated while your secondary WAN is doing nothing.
Backup connection or WAN fail over is to cover the loss of your primary WAN connection. This is often setup alongside load balancing.
As I mentioned trying to use your ADSL connection as a speed boost isn't really worth it if the speed is only 3Mbps down.
I presume you are only using the DSL for backup, not load balancing.
Unless you are doing QoS on your outbound traffic (like for VoIP) you might as well just set the sliders to their maximum values.
If you are not using traffic prioritization then as the other poster commented just set the wan values to the max. If you are using traffic prioritization then review the guide below that explains how that works.
Hey Blake thanks for the response. Yeah sorry for the confusion, I have it set to prefer the Comcast Business link but with Load Balancing enabled currently.
What's your opinion's, Chad and Philip, on load balancing between the connections versus just using the main Comcast connection unless we need the DSL connection.
Because then, the connection speed would be controlled by Comcast moreso than the MX64, if I'm understanding correctly, right?
I was originally thinking about this question because our load balancing values were set low and we were capping our own download speeds by having the MX64 traffic shaping values set too low.
I would not load balance. The speed difference between the two circuits is too big and will lead to poor user experience.