Meraki AP & Radius Integration

SOLVED
SLR
Building a reputation

Meraki AP & Radius Integration

Hello - 

 

I have been working a test network to get Meraki AP with Radius integration based on instructions in below youtube video. I found when I followed this video, I was not successful in my setup unless I removed the TunnelPvt-Group-ID (vlan number) attritube from the configure radius attributes piece. Once I removed that, I was able to get my devices connected to the wifi with WPA2- Enterprise (my radius server) User credentials are validated with 802.1X at association time

 

I also did not use vlan tagging

 

Is this approach not correct?

 

https://www.youtube.com/watch?v=mMSSfy_mIlQ

1 ACCEPTED SOLUTION
2 REPLIES 2
ww
Kind of a big deal
Kind of a big deal
SLR
Building a reputation

that is exactly what it was. We were using VLAN override. I just wanted to be sure that I was doing it correctly. I had the following set up:

1
Tunnel-Type = "VLAN",
2
Tunnel-Medium-Type = "IEEE-802",
3
Tunnel-Private-Group-ID = "128"


I kept the 1st two attributes and then removed the third one. Everything worked as it should.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels