MX 450 Install and config

[kfat32]

I have MX 450 connected to the WAN port, I can see the MX 450 on the dashboard, now I want to deploy MX 68W at the remote site. I do have DHCP server at the data center and the MX 68W will be installed on a remote location. I would like to know how the 68W will create a tunnel and get the configuration from The MX 4150. I am a NWB and would like to learn more about Meraki. 

Date center ---> Meraki 450MX -- Cisco switch ---Router-- ISP

remote site office --> MX 68W --ISP modem/router.

Thanks!

[cmr · Accepted solution]

On the Meraki dashboard you have one Organization with two Networks in it.  In one network is the MX450, in the other is the MX68W.  Under the Security & SDWAN heading simply enable the Site-to-site VPN.

Meraki magic will get you connected, though you can optimise the connection and secure traffic between the sites as well!

[kfat32]

@cmr Thanks for the reply, here is another question. I have MX 450 in NY and the other in CA.. I want the NY 68Ws to be connected to the MX 450 in NY and the ones in CA to be connected to the MX450 in CA. What is the best way to accomplish this. 

Thanks! 

[cmr]

Set the 68Ws as spokes and only have the hub you want: