Meraki

RahulPrasadh

We need to allow certain URL for accessing new MFA url, I have added URL to layer 3 outbound policy and whitelisted in content filtering and still unable to access, Is there any different config we need to do for allow new MFA url?

am-landing.i2.automate-webservices.com/?hac=H90AAWOK&userFullName=Amy Scaggs&username=awruck01

alemabrahao

Have you run a URL test to validate the category in which the URLs are classified?

Remember that after adding the URLs to the whitelist you need to wait a few minutes for it to actually be applied.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

alemabrahao

Check it out.

https://documentation.meraki.com/MX/Content_Filtering_and_Threat_Protection/Content_Filtering#Patter...

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

RahulPrasadh

Yes, tested category and it's allowed and added to allow URL but still we are unable to access.

alemabrahao

Try another way to add the URL, without HTTPs, with an asterisk in a part of the URL without pointing to the entire URL.

one of these ways will surely work.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Meraki

Community

MFA - Allowing URL

MFA - Allowing URL