How can I configure MX64 to direct wan1 to lan1 and wan2 to lan2?

[Vbrites]

Hello!

I have an MX64 and I would like to know how can I configure MX64 to direct wan1 to lan1 and wan2 to lan2?

I mean: I want MX64 to be in passthroug mode and direct wan1 only to lan1 and wan2 only to lan2 so I can install an loadbalance after it. I know that MX64 has a loadbalance function built in, however I want to use an dedicated hardware to do this.

PROVIDER1 -> WAN1 (MX64) -> LAN1 (MX64) -> WAN1 (LOADBALANCE) ...\_______> SWITCH -> PC
PROVIDER2 -> WAN2 (MX64) -> LAN2 (MX64) -> WAN2 (LOADBALANCE) .../

[ww]

Passthrough mode only supports a single wan1

https://documentation.meraki.com/MX/Networks_and_Routing/Passthrough_Mode_on_the_MX_Security_Applian...

[Vbrites]

Thank you!

If I use the router mode is it possible to  direct wan1 to lan1 and wan2 to lan2?

PROVIDER1 -> WAN1 (MX64) -> LAN1 (MX64) -> WAN1 (LOADBALANCE) ...\_______> SWITCH -> PC
PROVIDER2 -> WAN2 (MX64) -> LAN2 (MX64) -> WAN2 (LOADBALANCE) .../

[ww · Accepted solution]

You can set flow preferences.

For example 

lan1 is set to vlan1(10.0.0.0/24) to wan1

Lan2 set to vlan2(10.0.1.0/24) to wan2

https://documentation.meraki.com/MX/Firewall_and_Traffic_Shaping/MX_Load_Balancing_and_Flow_Preferen...

But its flow preferente. For example if wan2 fails. Both vlans will use wan1