cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Fully Redundant (Multiple Switches) - LOOP

New here

Fully Redundant (Multiple Switches) - LOOP

Hi all,

I trying to implementing this scenario but i faced with STP Loop,

My up-link port its BLK.

Both Meraki actin like a hub, then I just have 1 root bridge.

Some advice?

STP.jpg

5 REPLIES 5
Kind of a big deal

Re: Fully Redundant (Multiple Switches) - LOOP

Make the link between the switches the last port in each switch.
Kind of a big deal

Re: Fully Redundant (Multiple Switches) - LOOP

Another solution is to use LACP between the layer 2 switches. 

New here

Re: Fully Redundant (Multiple Switches) - LOOP

I did. I using 3750 Switch
Kind of a big deal

Re: Fully Redundant (Multiple Switches) - LOOP

I would recommend using MST mode on 3750's.

Spanning-tree mode mst

You can also set the port priority to make sure the port does not block.
New here

Re: Fully Redundant (Multiple Switches) - LOOP

Good! It's good by pass , lol THANKS
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.