Fully Redundant (Multiple Switches) - LOOP

Lucas_Ribeiro
Conversationalist

Fully Redundant (Multiple Switches) - LOOP

Hi all,

I trying to implementing this scenario but i faced with STP Loop,

My up-link port its BLK.

Both Meraki actin like a hub, then I just have 1 root bridge.

Some advice?

STP.jpg

5 REPLIES 5
PhilipDAth
Kind of a big deal
Kind of a big deal

Make the link between the switches the last port in each switch.

I did. I using 3750 Switch

I would recommend using MST mode on 3750's.

Spanning-tree mode mst

You can also set the port priority to make sure the port does not block.
PhilipDAth
Kind of a big deal
Kind of a big deal

Another solution is to use LACP between the layer 2 switches. 

Good! It's good by pass , lol THANKS
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels