DHCP config at MX 67

[Piysuh]

HI,

I m setting Up a Gold Site .

like in cisco Router , we create SVI for different vlan & we give Ip helper address x.x.x.x command to host ip via DHCP Server .

same i have to configured at Mx 67 under DHCP tab as i am getting Relay DHCP to another Server & where i gave DHCP server IP & when i gave DHCP server IP . after saving getting below error:-

• The DHCP option must be a valid integer.
• The DHCP relay IP address must be in a subnet connected to this Meraki network or to a Meraki network reachable through site-to-site VPN. Relaying through a non-Meraki VPN peer is not supported.

can you pls help me to config so thta we can ping DHCP server & test on user pc.

as i understand do we need to allow DHCP subnet to VPN Tunnel ?

[Kamome]

First, could you tell more specific configuration? I can't understand " i am getting Relay DHCP to another Server & where i gave DHCP server IP & when i gave DHCP server IP". Usually, "The DHCP option must be a valid integer." means you gave incorrect address or format.

Second, yes. You need to add DHCP subnet to AutoVPN tunnel to relay DHCP request to that server.

[Piysuh]

Hi,

we have US DHCP server IPs like :- 10.X.X.X & DHCP servers are in Data Center .

So in Cisco Router we configure These DHCP IP's as a helper address but here think its asking Subnet that we did not give .

that is my query .

Second, yes. You need to add DHCP subnet to AutoVPN tunnel to relay DHCP request to that server: you means that the DHCP server Subnet we need to add in AutoVPN ( how do you have any link where we add subnet Autovpn )?

[Kamome]

You can add static route to hub Meraki device.

https://documentation.meraki.com/MX/Networks_and_Routing/MX_Addressing_and_VLANs