Jul 13 2023
12:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 13 2023
12:27 AM
Configuring ethernet port link negotiatoin
Hello.
I am trying to use "setup.meraki.com" to configure the ethernet port negotiation setting on an MX64.
Its says the default password is the serial number of the MX.
Neither the serial number or my Meraki dashboard userid/password work.
any ideas?
many thanks
Ian H
Solved! Go to solution.
1 Accepted Solution
Jul 13 2023
2:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 13 2023
2:52 AM
On the network-wilde > general dashboard page you can see if a local status page password is set. Username admin
3 Replies 3
Jul 13 2023
1:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 13 2023
1:49 AM
Try using http://mx.meraki.com with the device serial (upper case letters and dashes) as username without any password.
Jul 13 2023
2:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 13 2023
2:52 AM
On the network-wilde > general dashboard page you can see if a local status page password is set. Username admin
Jul 13 2023
3:04 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 13 2023
3:04 AM
thank you!

Get notified when there are additional replies to this discussion.