Static IP routing to internal host through GX?

Solved
Dean_R
New here

Static IP routing to internal host through GX?

I have an exec that has an internal security camera system in his house that is accessible from the Internet via a separate static IP address. Am I able to add the ISP assigned IP block to the GX and then route one of the addresses to the security system? I have seen where you can do port forwarding, but I was hoping for static IP routing.

1 Accepted Solution
AMP
Meraki Employee
Meraki Employee

@Dean_R 

 

I believe you are referring to a 1:1 NAT in which case the GX20 does not currently support. We would suggest submitting a feature request to support 1:1 NAT.

Knowledge is power

View solution in original post

1 Reply 1
AMP
Meraki Employee
Meraki Employee

@Dean_R 

 

I believe you are referring to a 1:1 NAT in which case the GX20 does not currently support. We would suggest submitting a feature request to support 1:1 NAT.

Knowledge is power
Get notified when there are additional replies to this discussion.