Change: Added note that WPA2-Enterprise with Meraki authentication is not supported for wireless MX or Z-series models when in a combined network. In order to use this feature you will need to split the wireless MX or Z-series device into a standalone network.
Change: Added note that the Switching > Monitor > DHCP servers & ARP page displays information about any DHCP servers seen by Meraki switches on the LAN. From this page, administrators can also configure email alerts.
Change: Added MV including a note about one-way firmware upgrades; added note about maximum firmware for Z1s, MX60/Ws, MX80s and MX90s; added note that Z3 once updated to MX 14.31 or 15.8 and beyond will not be able to run any older firmware than MX 14.31 or 15.8.
Change: Added note about vMX acting as stateful firewall when in NAT mode, including tunnel and NATting behavior. Added two FAQs: "How to setup routing for NAT mode vMX on the cloud?" and "What does the traffic flow look like?".
Change: Added sections "Placement Guidelines", "Initial Considerations", "General Guidelines" and "Coverage Guidelines" as well as updated the FAQ with "What happens if I place the camera on a surface higher than the recommended 10-14 ft?" and "Can I replace all my cameras with a single MV93?".
Change: Added multiple sections "DFS Events alerts by Access Points", "Verifying DFS Events", "A high number of events", "Manually assign non-DFS channels to APs" and "RF Profile DFS channel exclusion".
Change: Edited the retention times for MT > Environmental Telemetry > Temperature, Humidity, Door, Water Detection to 1 year and Organization-wide Logs > Location Analytics > Heatmap (24 Hours, 1 Hour) to 1 month.