May 28 2020
10:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 28 2020
10:34 AM
Static IP routing to internal host through GX?
I have an exec that has an internal security camera system in his house that is accessible from the Internet via a separate static IP address. Am I able to add the ISP assigned IP block to the GX and then route one of the addresses to the security system? I have seen where you can do port forwarding, but I was hoping for static IP routing.
Solved! Go to solution.
1 Accepted Solution
May 28 2020
2:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 28 2020
2:08 PM
I believe you are referring to a 1:1 NAT in which case the GX20 does not currently support. We would suggest submitting a feature request to support 1:1 NAT.
Knowledge is power
1 Reply 1
May 28 2020
2:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 28 2020
2:08 PM
I believe you are referring to a 1:1 NAT in which case the GX20 does not currently support. We would suggest submitting a feature request to support 1:1 NAT.
Knowledge is power
Get notified when there are additional replies to this discussion.