API Endpoint to change LAN port to WAN2 on MX

Solved
KarstenI
Kind of a big deal
Kind of a big deal

API Endpoint to change LAN port to WAN2 on MX

Hi all,

 

the subject says it ... I would like to change my LAN2 port on an MX67  to WAN2 to use it as the secondary WAN. But I don't find the corresponding API-call ... Any hints?

 

Hope you have all a great holiday-time, Karsten

1 Accepted Solution
Ryan_Miles
Meraki Employee
Meraki Employee

There is no such API endpoint today

Ryan / Meraki Solutions Engineer

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

View solution in original post

6 Replies 6
Ryan_Miles
Meraki Employee
Meraki Employee

There is no such API endpoint today

Ryan / Meraki Solutions Engineer

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.
KarstenI
Kind of a big deal
Kind of a big deal

Okay, next week is still ok … 😉

HolgerS
Meraki Employee
Meraki Employee

Hi Karsten, you can do this by using the updateDeviceManagementInterface API endpoint and set WAN2 as enabled. This will complet the conversion 😉

 

https://developer.cisco.com/meraki/api-v1/#!update-device-management-interface 

 

 

 

Holger Struckmann
CCIE #60154
KarstenI
Kind of a big deal
Kind of a big deal

Thanks, I'll directly test this!

mgcnent
Conversationalist

Is there a way to do this for multiple devices at once? Kind of like the clone switch API endpoint but for the update device management interface? 

KarstenI
Kind of a big deal
Kind of a big deal

This call needs the serial-number of the device. You have to get all the serials of all intended networks and iterate over this list.

Get notified when there are additional replies to this discussion.