Pre-Configure MX uplinks

SOLVED
NC_Chris
Here to help

Pre-Configure MX uplinks

I am about to deploy another Meraki SD-WAN site for my customer tonight and when I log into the dashboard the uplink configuration for this MX is empty.  I use to be able to preconfigure the uplinks so when the MX reached out to the cloud it would take this static IP when it pulled the new config.  Does anyone know if the dashboard was updated to prevent uplink configurations prior to the MX checking into the dashboard the first time?

1 ACCEPTED SOLUTION
SoCalRacer
Kind of a big deal

As far as I was aware there was never a change, but it has always been that until the device checks in then the option to change the uplink wasn't available.

View solution in original post

2 REPLIES 2
SoCalRacer
Kind of a big deal

As far as I was aware there was never a change, but it has always been that until the device checks in then the option to change the uplink wasn't available.

I may have done the others as it checked in without paying attention maybe.  Just happened to notice it yesterday with a Z3 and today with an MX84.

Get notified when there are additional replies to this discussion.