Dashboard failing to display switches or access points

Solved
AdamNNTC
New here

Dashboard failing to display switches or access points

In the last month, I am no longer able to view on the dashboard a list of my switches or my access points for my site.  Is this a bug in the beta version, or something else.  We have not done any changes since initial installation.  Meraki has done a few firmware upgrades and this was noticed shortly thereafter.  Is there a fix?  It briefly tries to show the list of switches and access points, but then the error message pops up and will not go away after a page refresh.

 

AdamNNTC_0-1675202840652.png

 

AdamNNTC_1-1675202873307.png

 

1 Accepted Solution
Ryan_Miles
Meraki Employee
Meraki Employee

You should open a Support case

Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

View solution in original post

3 Replies 3
alemabrahao
Kind of a big deal
Kind of a big deal

Have tied it with another web browser?

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
AdamNNTC
New here

Yes. I get the same results using Chrome as well as Microsoft Edge.

Ryan_Miles
Meraki Employee
Meraki Employee

You should open a Support case

Ryan

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.
Get notified when there are additional replies to this discussion.