Meraki

Kevin_Monsta

Hi, anybody know why AP can not stand alone as AP? i have 1 AP that connected as repeater even i have set the IP before. it connected to switch and not using power adaptor

RWelch

Gateway AP Switches to Repeater Mode

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

Kevin_Monsta

i cant open the link

alemabrahao

It's very likely that this isn't connecting to the internet.

Can you verify the IP address configured on the dashboard when it's set up as a repeater?

Try performing a factory reset

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Kevin_Monsta

we have set the IP, but we cant change the IP then. the IP not shown on dashboard.

this is new AP, should i do factory reset?

alemabrahao

Try performing a factory reset please.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Meraki

Community

Access Point as reapeter

Access Point as reapeter