Why is the WAN IP of my Meraki MX responding to DNS queries and acting as a name server?

[srajiwate]

Why is the WAN IP of my Meraki MX responding to DNS queries and acting as a name server?

I noticed that the WAN IP configured on my Meraki MX is responding to DNS queries and appears to be acting as a name server. Is this expected behavior, and if not, how can I disable this functionality or secure it properly? Are there specific configurations or best practices to prevent this from happening?

[alemabrahao]

Yes, It is probably configured in the MX configuration to use it as a proxy.

[alemabrahao]

https://documentation.meraki.com/General_Administration/Cross-Platform_Content/Configuring_DHCP_Serv...

[srajiwate]

I had validated this it is for inbound to outbound  access there is no issue related to this issue is from outbound to MX and MX acting as name server to respond dns query  

[JonnyM]

Do you have the NAT exceptions feature enabled?

[srajiwate]

During a recent penetration test, it was observed that the WAN IP of my Meraki MX is responding to DNS queries, even though the MX is not configured as a name server. This behavior is raising security concerns and impacting the test results.

Is this expected behavior for the MX? If not, is there a way to mitigate or disable this functionality to ensure the device does not respond to DNS queries on the WAN interface?

Thank you in advance for your guidance and any best practices you can share!

[alemabrahao]

Did you check the link I sent you?

[srajiwate]

Yes thanks for the link will validate the setting in our environment first based on the document you shared

[alemabrahao]

The Meraki MX should not typically respond to DNS queries on its WAN interface.

You can create a rule to deny inbound DNS requests (port 53) on the WAN interface. If the issue persists, it might be best to contact Meraki Support.

[srajiwate]

But the query is that only is Meraki MX responding on WAN IP over the public IP  

[ww]

Did you test that from your lan side? Or from another public ip or public port scan tool?

From the outside everything should be denied. Unless you maybe enabled no nat

[RaphaelL]

I have a spare MX on my LAN at home and the MX is also responding to DNS queries on the 'WAN' interface but not on it's "LAN" interfaces.

Run a DHCP Server is not enabled.