MA-ANT-C1-A extended antenna cable

Solved
ruudnouris
Conversationalist

MA-ANT-C1-A extended antenna cable

Hi,

 

The MA-ANT-C1-A comes with a 100cm antenna cable. Is it possible to use a 200cm cable?

Is there a Meraki productcode for available, or must i use third party cables?

 

Thanks!

 

Kinde regards

Ruud Nouris

1 Accepted Solution

The leads are fixed to the antenna

Ryan / Meraki Solutions Engineer

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

View solution in original post

5 Replies 5
Ryan_Miles
Meraki Employee
Meraki Employee

The MA-ANT-C1-A is a dipole antenna for the MG21E. It has no cable as it directly attaches to the MG. Any cable extenders would be 3rd party.

Ryan / Meraki Solutions Engineer

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

Hi Ryan, sorry, I ment the MA-ANT-C1-B.

Same answer would apply. Any cabling beyond what's attached to the patch antenna would be non Meraki.

Ryan / Meraki Solutions Engineer

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

So can I replace the cable, or should I extend it. I mean is the antenna cable fixed to the antenna or is it connected via connectors.

The leads are fixed to the antenna

Ryan / Meraki Solutions Engineer

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.