Just to give an update.  The APs are now registering with the Meraki controller properly and showing online.  It was an odd experience that the APs were not accessible for management through the "Wireless -> Access Points" menu but were if accessed through "Organization -> Overview" and then the devices tab.     I am going to chalk it up to a glitch on Meraki's side as I didn't make any changes on my end over the few hours. ... View more

There are a mix of MR-46,42,52.  I had 3 of the MR-46 earlier today that were on Repeater mode and most likely due to a bad wire.  There are 48 access points at this site (45 were fine a few hours ago).  Change log shows that no changes had occurred to the controller over this time period.  My other site is fine.     All APs are setup for PoE from the switches.  Actually 1 AP has an AC Power Adapter out of the 48.   I am not sure what version they are running.  The APs are not loading in the control panel and the web gui for the AP itself does not give that data.   Even more strange.  If I go to the Organization menu and then Devices, the APs show online and connected.  The AP data even loads.  The AP version of one of the MR-46 is Current version: MR 29.5.1.   ... View more