Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About WhoIsThis
WhoIsThis
Comes here often
Member since Aug 11, 2023
Oct 22 2023
Community Record
4
Posts
0
Kudos
0
Solutions
Aug 12 2023
8:20 AM
I created tags and implemented them as a workaround to restore the previous physical setup. I used the SSID Availability feature to limit which was broadcast by which AP. What is the alternative to using tags? What is your recommended configuration?
... View more
Aug 11 2023
10:51 PM
I think we're on the same page as that's something else I tried, however, and this may be what threw me off, is the "All other APs" fields, what should that be set as? I haven't implemented the changes, I just want to confirm with the images your recommendations. VLAN Tagging Office VLAN Tagging Store Trunk Port
... View more
Aug 11 2023
10:37 PM
I think this is what you're asking for. If not, I can take some more. The config for both SSIDs are the same, less the WPA key. The trunk port makes sense, and I did try that, but like I said originally, it's like the IPs are too sticky, they stay with the device regardless of which network they are connected to. MX Port Config SSID Config 1 SSID Config 2
... View more
Aug 11 2023
9:30 PM
I tried typing out the entire setup and it turned into a convoluted mess, so this is the essence of what the problem is: MX67 Port 3 = Store Network - VLAN 1 - Trunk Port - 192.168.101.0/24 - Store SSID Port 5 = Office Network - VLAN 149 - Access Port - 192.168.0.0/24 - Office SSID x6 MR33 APs 6 SSIDs - 1 Store / 1 Office / 1 Employee / 3 Guest (varying restrictions) - Employee and Guests are in isolated networks. I want all SSIDs to broadcast on all APs, however, when a device connects to the Store SSID on an AP connected to/through port 5, it gets an IP in the Office range. The 2 networks should be completely independent as I segregated them by VLANs, however, sharing the APs shouldn't be a problem as far as I know, but maybe I'm wrong. I thought the solution was to set Port 5 to a trunk port with the Native VLAN as 149, but that didn't work. The IPs were still from the wrong range, it's like the IPs are sticky to whatever they get, even after refreshing them. This seems like it should be really simple, but I'm clearly missing something. Thanks in advance for any guidance and help.
... View more
© 2024 Cisco Systems, Inc.
