About Adam5

Adam5

Thanks for the info. I turned this on for a test and the AP was blocked as it couldn't verify with Meraki. Is there something I am missing maybe in my firewall rule?

Adam5 · ‎08-22-2023

Good morning, Just checking in here to see if anyone would know a way to have the Meraki switches to auto detect when a new Meraki AP is connected and configure the port as a trunk with the proper vlans allowed. I heard from someone recently that this might be possible. I have 200 AP's that I am getting ready to deploy and changing each access port from our old system to a trunk with the new one would be tiresome. Trying to figure out if this can be a little more automated. Thanks for any advice. Adam

Adam5 · ‎07-10-2023

Thanks for the reply. Could be a possibility. We are looking for an overall "Kill Switch" that doesn't kill the config in case of a cyber attack. We could always unplug the cores but it wouldn't help us in our recovery if we are bringing things back online in a systematic way.

Adam5 · ‎07-10-2023

Good morning, Looking for something that can be done in the event of a cyber attack. We completed a table top last week and it came up that when we need to pull the plug for the entire network is there a way to disable all routing on our Meraki cores without deleting all the routes? This would help to mitigate the spread laterally across the network if something were to happen. Looking to see if there would be some other way around it or a script that could be run to accomplish this. Any advice would be appreciated. TIA Adam

Adam5

Community Record

Re: Meraki AP Deployment

Meraki AP Deployment

Re: Disable routing on the core

Disable routing on the core