Meraki

Community

About Mud_Flaps

Re: Action Needed pop up for one SSID when connecting

by in Wireless
‎Jan 11 2024 9:29 AM
‎Jan 11 2024 9:29 AM
Thanks for this! Pretty much what I was thinking. I haven't been able to easily test this because once I get connected on a device,  I don't see that windows pop up again for quite some time. It's not as easy as disconnect, turn off that policy, try again.    I'm pretty confident the device policy is at fault here. At some point I will just turn that off for a period of time and see what if the windows pop up is gone.    Thanks!  ... View more

Re: Action Needed pop up for one SSID when connecting

by in Wireless
‎Dec 28 2023 4:58 AM
‎Dec 28 2023 4:58 AM
Our testing proved out pretty successful in stopping mobile devices from connecting, granted it's based on connection information being shared during association, and can definitely be spoofed, but overall it prevented most mobile's from connecting.    We have not seen it prevent a non IOS/Android device from connecting so far.  ... View more

Re: Action Needed pop up for one SSID when connecting

by in Wireless
‎Dec 27 2023 5:58 AM
‎Dec 27 2023 5:58 AM
I do find the device policies helpful for stopping mobile devices from connecting to some of our networks, that is why I'm keeping it on so far. Thanks ... View more

Re: Action Needed pop up for one SSID when connecting

by in Wireless
‎Dec 22 2023 10:57 AM
‎Dec 22 2023 10:57 AM
This is the message that comes up:   ... View more

Re: Action Needed pop up for one SSID when connecting

by in Wireless
‎Dec 21 2023 12:50 PM
‎Dec 21 2023 12:50 PM
Hi guys, we are running MR44 AP's and it's on version MR30.5 firmware.    This only happens on one of the SSID's we have the same auth setup for all of them. PSK (WPA2) ... View more

Action Needed pop up for one SSID when connecting

by in Wireless
‎Dec 21 2023 11:04 AM
‎Dec 21 2023 11:04 AM
Hello all, curious why one of our SSID's always has a windows pop up when auto-connecting. It says Action Needed to connect to the SSID. If you click on that it doesn't take you to a splash page or anything, and it then just works. Even if you just leave it sit for a bit it will eventually go away and work.    I was curious if this had something to do with my policy to block IOS/Android devices from that network, seemed to start noticing those prompts around same time we started blocking those devices.    It doesn't pop up every time you connect, but if you don't connect for a day or two it will then pop up the action needed.   Any ideas?    Thanks!  ... View more
© 2024 Cisco Systems, Inc.