Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Zulan
Zulan
Here to help
Member since May 22, 2023
Dec 6 2023
Community Record
8
Posts
0
Kudos
0
Solutions
Badges
Nov 14 2023
4:01 AM
Hello Philip, thanks for your answer. I have created rules for udp 1812 and 1813. I get the mentioned events on the server everytime I try it so I guess it is able to reach the server. I have also double checked the secret to the radius server and it seems correct. I have now been going through the gui and I can not find anything about keys to the clients. Where do you set that?
... View more
Nov 14 2023
3:59 AM
It's all quite confusing to be honest since I'm not only new to Meraki. The network itself is now without an administrator and I can't find any documentation. Anyway, I ran a certutil and it sais the authority is on a server not available anymore and no one seems to know about it. I could install a new authority but I am worried about the implications of that. Still not sure it's the solution to the problem either.
... View more
Nov 13 2023
7:47 AM
It seems I have a self signed certificate, should it still be moved? The new server has another name and that servername is now in the certificate list for the new server. Just like the old server has the old server name, this just seems correct to me?
... View more
Nov 13 2023
6:16 AM
No, I have not. I have not set this up but rather inherited it so I'm not sure on how to do that. But this is probably a good place to start. I will read up and investigate that.
... View more
Nov 13 2023
6:02 AM
Hello, I am moving all my on prem servers remotely. I have created a new NPS installation on a new server. I then exported the NPS configuration I had on-prem and imported it to the new server. It starts up fine and I can see all my access points under Radios Clients. If I test the radius server from the cloud gui it can access the points, but fails on all of them with the message Failed to connect to the RADIUS server. Checking the eventviewer on the new server I get a ton of Event ID 6274. Network Policy Server discarded the request for a user. Reason Code: 1 Reason:An internal error occurred. Check the system event log for additional information. The system event log shows nothing. If I test using my old NPS server with the same config, it works perfectly. I have no idea what to test or even start troubleshooting this, any ideas?
... View more
May 22 2023
5:09 AM
No, the new VPN tunnel is not to azure. It's a local co-location provider. I actually had a hunch that was the answer. Thanks!
... View more
May 22 2023
4:59 AM
I will try, I have been asked to help out with this network and actually know quite little about it. But there has been a site-to-site VPN to some Azure servers for quite some time. Traffic works perfectly from the main network and from all the branch offices to this azure network. Then a new a new co-location was needed. A new "Non-Meraki VPN Peer" was setup with availability set to "All networks" the same as Non-Meraki VPN tunnel configured to Azure. But pings from the co-location works to all networks except Azure.
... View more
May 22 2023
3:52 AM
Hello! I'm having trouble getting traffic to flow from one site-to-site network that is a co-location network to our Azure network also connected with a site-to-site ipsec tunnel. It works from all other branchoffices but from the co-location network. I'm not sure where to start troubleshooting this, might be even be on the azure side. Any ideas what to check?`
... View more
© 2024 Cisco Systems, Inc.
