Meraki

RPM · ‎Jul 17 2023

Yes, it was working fine for 2 days or so, then as you can see in the graph below there was an outage (not sure what cause was), then it swapped to SIM #2. Now that SIM#2 is active, how do i remotely change it to SIM#1? I had rebooted the router to see if it would swap back to the primary, but it stuck and is staying on the secondary... Can i change the APN on SIM#2 to something invalid to force it back to SIM#1? Also.. regarding the firmware upgrade for this MG... I have selected that we can use beta firmware, but the MG section is greyed out, was hoping to try this upgrade as a possible fix, and in the event it works fine, start using this firmware on the other 20 MG's i'm about to deploy... Thanks!

RPM · ‎Jul 14 2023

Hi, I have installed an MG51 and MR36 at a remote site. The MG has VZW(SIM1) and AT&T(SIM2) SIM installed. When it was installed the MG51 was using VZW(SIM1), and had ok signal strength. over night, the signal strength dropped on VZW, and it switched to AT&T(SIM2). Now the AT&T connection is shown as poor. Can I manually swap the MG51 to use the VZW SIM? Follow up question, I changed the firmware setting to allow it to use beta firmware. However, under the section where i can make selections for the cellular gateway firmware, it is greyed out. The MG51 is running on v1.11 firmware at the moment. Any help would be appreciated. Thank you!

Meraki

Community

About RPM

RPM

Community Record

Re: MG51 - Can i manually switch the SIM the MG is using remotely?

MG51 - Can i manually switch the SIM the MG is using remotely?