Meraki

KSanderson · ‎Jul 27 2023

Sorry, maybe I haven't explained properly - the MS doesn't connect directly to the internet via a public IP - it backhauls to the Datacenter for Internet connectivity - this is for connectivity to the WAN. What we have on the Cisco ports is ip address 192.168.124.X 255.255.255.252 ip ospf network point-to-point ip ospf 1 area 1 ip ospf cost 1 The other link has a higher cost. In both cases, the other IP in the /30 is the carrier router. My thinking was to create 2 VLAN interfaces with the IP addresses and assign them to OSPF with the carrier IP as the gateway. The problem is what management IP can I add to the MS425 to allow connectivity?

KSanderson · ‎Jul 27 2023

We currently use Cisco Catalyst switches and are migrating to Meraki MS425 as our core at each site. We have 2 IPVPN links at the site that are currently configured as 2 P2P /30 links between the interface on the Catalyst and the providers router and we use OSPF. Is it possible to migrate the 2 /30 links over to Meraki directly or do I need to involve the carrier to change the IP addresses of their routers into a /29 so that the 2 Meraki MS425 can have a management IP in the same VLAN and use the carrier router as the default gateway? (we have done it that way at another site but this one is configured differently with the 2 /30 subnets and I'm trying not to have to get the WAN provider involved if at all possible). Thanks.

KSanderson · ‎Mar 7 2023

Hi. The suggested rule for Cloud Archive is to open port 443 to destination ANY. That is far too broad for us to implement so is there a URL that the cameras use to upload the footage to cloud storage? There must be something set as it can't just broadcast the footage to all addresses 🙂 Any help is appreciated.

Meraki

Community

About KSanderson

KSanderson

Community Record

Badges

Re: Migrating from Catalyst to Meraki - WAN link configuration

Migrating from Catalyst to Meraki - WAN link configuration

MV Cloud Archive Firewall rules