Meraki

Matt84043 · ‎Jun 8 2018

I have a couple of MS250s in a stack and a handful for aggregated pairs of switch ports between the two switches in the stack. I'm not clear what the "RSTP" value means in the dashboard for the switch ports. One shows forwarding and the other shows enabled. What is the significance of "forwarding" vs "enabled"? Basics of the setup: Switch A and Switch B are the stacked switches. Port 43 on each switch are aggregated access ports on vlan 85. "RSTP" is enabled and "STP Gaurd" is disabled. The switch ports are connected to NICs on a PowerEdge server. The server is running Windows Server 2016 with NIC teaming configured as LACP in dynamic mode. This is the case for half a dozen other aggregated pairs of switch ports on these switches as well.

Matt84043 · ‎Jun 7 2018

That's how I'd interpret this in our case. The MPLS circuit is delivered to us as basically a layer 2 connection (a P2P connection). There's no IP communication with the provider.

Matt84043 · ‎Jun 7 2018

In the diagram of the MPLS Failover to Meraki Auto VPN document, there are two router symbols on the MPLS cloud indicator with last octect numbers of .249. I'm not clear where those .249 interfaces would be configured. Would that be VLAN interfaces on each router at the other end of the MPLS circuit with VLANs trunked between the two sites over the MPLS connection?

Meraki

Community

About Matt84043

Matt84043

Community Record

Badges

Meaning of "RSTP" value for port view of aggregated switch ports

Re: Question about diagram on MPLS Failover to Meraki Auto VPN Diagram

Question about diagram on MPLS Failover to Meraki Auto VPN Diagram