Yes, I just updated the firmware on three of my Z3s yesterday and after reboot, they each took anywhere from 15 to 20 minutes before any traffic was routed down the WAN interface. (I probably should have documented it with some screenshots, but I just went about doing other tasks while waiting for them to come back). So to clarify, upon reboot, within a few minutes they are detected by the Meraki dashboard, appliance status indicates an active wan connection, but if I initiate a ping to anything on the other side of the VPN, for 15 to 20 minutes I get 100% packet loss. If I to to the Tools, I can ping the WAN appliance, run traceroute, MTR, DNS lookup, and ARP table all work fine, but I cannot ping anything on the other side or traceroute to the other side for 15 to 20 minutes. If I navigate to the VPN status under the Monitor options it knows it is suppose to be looking for the MX68 peer, but the status dot is red and the connectivity indicator bar is red. Uplink decisions indicates that it is seeing the MX68, but no packets are flowing. The three indicators: VPN Registry, NAT type and Encrypted are all green as well. Hope that helps. Very odd.
... View more