We have Meraki MR36H accesspoints with "wired_only" SSIDs connected to our MX95 custer. When a  device  is connecting to one of the physical ports, it authenticate and gets the correct vlan by asking our Cisco ISE. This works fine and we can run both MAB lists and dot1x. However, after some time the vlan number disapears in the client list and it's says "native" (see image). The device stops working and the only way to get it back is to reboot the AP 1 or 2 times. We monitor the devices by pinging them. The Meraki log is clean. I tested to set a vlan under "vlan tagging ID" and that works, even though I get an error msg while saving changes. Any ideas?     We are running firmware 30.7 in the AP.   ... View more

Greetings. We are running a network with mostly MR44s and some APs randomly goes in to "Low Power Mode". Unfortunaltly there is no SNMP Trap, syslog or Webhook for this event and we would like to be notified somehow.    The interface (Wired0) sometimes also go into 100Mbit instead of 1 Gigabit. Often due to old/bad cables. Same problem here. It's hardly impossible to manually check hundreds of APs manually.    I tried to walk the MIB on the accesspoint. I have so far not found any interface speed or power mode status to poll. I also looked at APIs to extract this inforamtion. I could check for changes at interface speed in the switch. Same for power that drops to 25 watt allocated instead of 30 watt.  ... View more