Meraki Community

YouTee · ‎Dec 5 2022

Got this sorted. Here is my solution: Guest SSID Security - Open Splash page - None (direct access) Necessary vlan tag ID Wireless>Firewall & traffic shaping On my Guest SSID, I add a rule i.e., allow ipv4 TCP to my guest gateway (guest interface on my pfSense) destination port 8002 which is the default port for pfSense CP

YouTee · ‎Dec 1 2022

I've tried that option to no avail.

YouTee · ‎Dec 1 2022

My current setup works with Unifi AP/Controller and CP/DHCP via pfSense. Am trying to incorporate Meraki to the current setup to test and will setup another scenario later where Meraki will be the CP itself. So, no there is no issue on the CP side AFAIK

YouTee · ‎Nov 30 2022

I'm not using splash page. I'm getting my CP via a firewall(pfsense) which is also the DHCP for my guest access

YouTee · ‎Nov 30 2022

Hi, I'm testing two Meraki switches and two access points. Got two SSID configured, and one is using 802.1x with Windows server 2016 NPS and this works well. Got another SSID that is intended for Guest access and is open and I'm using a different device for captive portal to allow access. Able to get the right IP address (from the device used for captive portal) on the right VLAN however I can't seem to get the CP page pop up so I can enter the credentials to log in for access Probably something I'm missing. Any assistance will be really appreciated

Meraki Community

About YouTee

YouTee

Community Record

Badges

Re: Captive Portal Doestn Work

Re: Captive Portal Doestn Work

Re: Captive Portal Doestn Work

Re: Captive Portal Doestn Work

Captive Portal Doestn Work

Re: Captive Portal Doestn Work