Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About TeckBoy
TeckBoy
Comes here often
Member since May 28, 2018
Jun 4 2018
Community Record
5
Posts
0
Kudos
0
Solutions
Badges
May 31 2018
9:20 AM
Hi. enable band steering. A: Enabled. set minimum bitrate to 12 or up. A: Configured to 12 or up make sure your client driver are up to date. A: drivers are up to date. you could also make a seperate ssid for 5ghz only. A: 5ghz is configured, 2.4 ghz is disable The result is the same, I receive 15 Mbps, my bandwidth is 100 Mbps.
... View more
May 30 2018
1:49 PM
Hi Thanks for your replay. I have clients working with equipments in 2.4 ghz. If I disable 2.4 ghz band, those clients will have problem to connect to wireless.
... View more
May 30 2018
1:44 PM
Hi Thanks for your replay: does the throughtput test on the AP gives you +/- 100Mbps? A: Yes up to 90 Mbps. any errors on the switchport of the AP your connected? A: No errors. did you try other cliënts? A: Yes, same issue. is the current utilization of the AP's low? A: it is normal. when your client is connected and you check the AP, What channel is the client on? A: channel 6 and 11.
... View more
May 28 2018
7:46 AM
Hi Community: I'm confused with an implementation. I've installed and configured a Cisco Meraki solution, I have MX100, MS 425 and nine access points MR 53. My bandwidth is 100 Mbps. Everything is working, however when I connect to the switch via ethernet my bandwidth is 98 Mbps download, but when I connected via wireless my bandwidth is about 9-15 Mbps. The network isn't in production, yet. Access Points have full coverage and the assign channels are in automatic. Any idea what can be the problem? Any suggestion? Thanks in advance.
... View more
© 2024 Cisco Systems, Inc.
