Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About MarcW

MX85 to other brand firewall - VPN does not sustain with failover to backup...

by in New to Meraki
2 weeks ago
2 weeks ago
I tried to make the subject all the key details.  I have a successful MX85 to TZ VPN connection on my primary ISP.  The HA failover VPN works because I set up a VIP for the redundant MX85's.  However, when I fail test the ISP, the internet is accessible, but the tunnels never re-establish over the VPN.  I have the 2nd IPSEC on the other end set to what becomes the new Public IP on the MX85 backup.  I waited a good 10-15 minutes to see if the tunnel would ever re-connect.  No joy.  I am sure there is some fundamental step I am missing, but it eludes me.  Reading is fundamental, but apparently firewalls are not.  ... View more

How to configure MX85 for SFTP and allow a particular IP address

by in Security & SD-WAN
3 weeks ago
3 weeks ago
I have a client that wants to use SFTP.  I have an MX85.  They want to send and receive data.  I have an IP that I want to allow.  What entries are needed to configure this?  I am guessing I start under firewall.  After that, looking to learn.  ... View more
Labels:

Re: Secondary of Meraki HA Config Offers Different IP that other VPN'd Fire...

by in Security & SD-WAN
‎Mar 22 2024 12:28 PM
‎Mar 22 2024 12:28 PM
Thanks but no.    Went to Uplink.  Edited spare to use virtual.  Same IP range but different that anything already set.  Was the Public IP supposed to change to match the new VIP set?    After setting virtual, the public never changed and my other firewall never re-established the tunnel.  My failover then kicked in shortly after for my secondary IP source.  ... View more

Secondary of Meraki HA Config Offers Different IP that other VPN'd Firewall...

by in Security & SD-WAN
‎Mar 19 2024 1:32 PM
‎Mar 19 2024 1:32 PM
I have HA Merakis VPN'd to a SonicWall (changing this as soon as possible).  I have 2 ISPs connected to the Meraki.    During testing, when I swap from HA1 to HA2, HA2 offers a different IP than HA1.  The SonicWall VPN is configured for the HA1 IP address.    Also, the secondary IP on the SonicWall is set to connect with the secondary IP from the Meraki (ISP failover).    If I set both HA1 and HA2 to the same IP, I get a conflict.  How do I overcome this?  ... View more
Labels:
© 2024 Cisco Systems, Inc.