Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About MarvinV

Re: Z3 Templates Addressing and Vlans

by in Security & SD-WAN
‎May 15 2018 10:27 AM
‎May 15 2018 10:27 AM
Good point. I'll get my firewall opened up to allow the access and I should be good. Thanks for the info. ... View more

Re: Wish: Template improvements

by in Dashboard & Administration
‎May 15 2018 9:31 AM
‎May 15 2018 9:31 AM
After using Meraki for a short time I see this feature being a requirement. I started out using templates as they can make life much easier. However the templates take all the flexibility away for basic port level troubleshooting, enabling ports on specific appliances, doing smaller scale upgrades of firmware, etc....So for now I'm afraid I'll have to go back to not using templates until Meraki puts more focus on it. Recently sat with another vendor of a similar product that allows the granular changes needed while still supporting the templates. ... View more

Re: Z3 Templates Addressing and Vlans

by in Security & SD-WAN
‎May 15 2018 9:27 AM
‎May 15 2018 9:27 AM
In less I'm missing something the issue I see with the local status page is how to access it in our deployment. We have Z3 appliances that sit behind a cable modem at a users house. How is one supposed to access the local status page as the cable modem/and or a soho router at the users house is not going to allow an inbound connection to the meraki unless you have configured it to do so. Not really an option. ... View more

Z3 Templates Addressing and Vlans

by in Security & SD-WAN
‎May 11 2018 7:35 AM
‎May 11 2018 7:35 AM
We are using Z3's and are using templates to help maintain consistency and to ease deployment. We have set the template up for vlans so that we can manage and define each port of the Z3. The issue is if we want to enable/disable a port on a single Z3, that is part of a template, we are not able to do this. You have to manage the ports in the template which affects all Z3's that are part of the template. We need the ability to at least enable/disable the port of a single z3 to help with issues within a single location. Anyone else run into this? I also made a wish for this though it would be nice to see if this feature has ever been requested and if its on the radar to add. ... View more
© 2024 Cisco Systems, Inc.