Meraki

Matt75 · ‎Apr 27 2022

Nic drivers have been updated and home subnets are different. I was able to somewhat replicate it using my hotspot connected to vpn. I turned hotspot off without disconnecting vpn. Then I connected to the client wireless (Meraki) and wasn't able to hit LAN addresses. Surfing was fine though.

Matt75 · ‎Apr 25 2022

Hello- I have a couple of users that use the Meraki vpn at home. When they come back into the office, they can't access LAN resources. They connect to the wireless, but can't access onsite servers, etc. We have to remove/reinstall the nic. Anyone have any experience seeing this? I believe they don't disconnect the vpn or shutdown/reboot their laptops before coming back into the office.

Matt75 · ‎Mar 9 2022

You are correct. The ip's on the /29 do need to be accessed outside. I would have to NAT the outside addresses to the private LAN address (192.168.176.x).

Matt75 · ‎Mar 9 2022

Hello, We are moving to a new ISP. We've been given a WAN /30 block, and an additional LAN /29 block. I have my WAN eth01 configured for the /30 address (xxx.xxx.206.206). I'm not sure the best way to setup the additional /29 ips (xxx.xxx.206.234-238) to NAT to inside/private LAN addresses. Thanks, Matt

Meraki

Community

About Matt75

Matt75

Community Record

Re: Client vpn users (2) can't access onsite network with back at office

Client vpn users (2) can't access onsite network with back at office

Re: Moving to a new ISP

Moving to a new ISP