Got it, thanks! Got this working by printing the verbose messages, with something like mosquitto_sub -v -t meraki/v1/mt/[NETWORK_ID]/ble/# Appreciate all the team's help here! ... View more

Ah thanks David, I missed the part that data is only pushed every 20 minutes if no change in state is detected. One last questions on the + and # wildcards: would it make more sense to include the MAC address in the message? Otherwise, it's not clear which sensor the message originated from. ... View more

Thanks, so I upgraded my MR network to 28.6 and MV to 4.16, but don't see any messages coming through. I don't think it's the MQTT broker's issue as I duplicated the configuration from MV Sense, which is working fine with the exact same setup.   Is there something else that needs to be done? I also tried device MAC in both lower-case and upper-case, as well as leading slash "/" on the MQTT topic (like MV Sense) and not (as shown in the "MQTT Topics" section), but none of the four combinations seems to work.   Thanks again for your help, @David-H! ... View more

Besides upgrading MV to 4.16--which I've done, but still don't see the "MQTT Brokers" tab--what else is needed to get MT MQTT working? Is it an absolute requirement to run MR at 28.6 as well, or just one or the other? ... View more