Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About Yanik

Re: MS L3 interfaces MAC addresses?

by in Switching
‎Oct 4 2021 2:37 AM
‎Oct 4 2021 2:37 AM
Hello @cmr, not sure this concept of master switch with lowest MAC address works in Meraki context, probably more related to Catalysts. And the MAC addresses I found in device's ARP table have nothing to do with the MS physical addresses. Also, it appears that the same MAC address on one stack is used for all L3 Interfaces. ... View more

MS L3 interfaces MAC addresses?

by in Switching
‎Oct 4 2021 12:45 AM
‎Oct 4 2021 12:45 AM
Hello,   I'm using MS250 stacks as L3 switches, so I have L3 interfaces configured at the stack level for each VLAN.   I've been requested to provide the MAC addresses of each IP associated to the interface on the VLANs, but so far, the only solution I found is to get the MAC from the ARP table of a devices in the LAN, which is not convenient at all, especially that I don't have access to devices in some VLAN. And the worst part is that looking for this MAC in the MAC address table of the stack doesn't return anything.   Also, nothing tells me how this MAC is built up, if it is persistent, if it changes when the switch/stack reboots or following an upgrade.   I've checked: In the dashboard through the API In the documentation In the forum   But was not able to find answers to this question. Does anybody have a solution to this?   Best regards,   Yanik ... View more
Labels:
© 2024 Cisco Systems, Inc.