Meraki

IdealCH · ‎Apr 11 2018

It's on DHCP now, it didn't take effect until the MX84 rebooted after a firmware upgrade last night but the issue seems to be with the mobile broadband provider from what I can tell.

IdealCH · ‎Apr 11 2018

Some further information I have discovered. The mobile broadband provider I am using is Vodafone Ireland. I can ping but not traceroute external I.P. addresses. When I change the SIM to a Three Ireland I can traceroute. I've not yet tested full connectivity using the Three SIM as I don't want to knock the office offline but it seems that Vodafone have some restrictions on their network that is causing the problem. Any thoughts?

IdealCH · ‎Apr 10 2018

Hi Adam, A quick note first of all, the device is an MX84 not MX80 as I stated incorrectly earlier. I'm not sure about what you are asking me to do. When I look at the appliance status page I see this and this I looked everywhere but I can't see where I can check the port.

IdealCH · ‎Apr 10 2018

Hi All. First time poster here so I hope you can help me out! I'm trying to set up Wan 2 on my MX80 but the link is showing a failed state. I have a Huawei AF23 Sharing dock with a USB cellular modem plugged into it. The device it connected by Ethernet cable to Wan 2. I have tested it connected directly to a laptop via cable, wirelessly and also through a switch. All scenarios work. When connected to the MX80 Wan 2 port, the link status shows this (Full I.P.'s not shown here for obvious resons): WAN 2 STATUS Failed IP (STATIC) 87.192.xxx.xxx VIRTUAL IP GATEWAY 87.192.xxx.xxx DNS 62.231.xxx.xxx 62.231.xxx.xxx What could be the problem here?

Meraki

Community

About IdealCH

IdealCH

Community Record

Badges

Re: MX80 Wan 2 Link failed

Re: MX80 Wan 2 Link failed

Re: MX80 Wan 2 Link failed

MX80 Wan 2 Link failed

Re: MX80 Wan 2 Link failed