I can not look at the log message to tell what happened.   But I can see the status of the connection to find the access point. It indicates the connection status as "2D".   Flags: 1 = 802.1x authenticated AP use EAP-PEAP; 1+ = 802.1x use EST; 1- = 802.1x use factory cert; 2 = Using IKE version 2 B = Built-in AP; C = Cellular RAP; D = Dirty or no config E = Regulatory Domain Mismatch; F = AP failed 802.1x authentication G = No such group; I = Inactive; J = USB cert at AP; L = Unlicensed M = Mesh node N = Duplicate name; P = PPPoe AP; R = Remote AP; R- = Remote AP requires Auth; S = Standby-mode AP; U = Unprovisioned; X = Maintenance Mode Y = Mesh Recovery c = CERT-based RAP; e = Custom EST cert; f = No Spectrum FFT support i = Indoor; o = Outdoor; s = LACP striping; u = Custom-Cert RAP; z = Datazone AP p = In deep-sleep status 4 = WiFi Uplink r = Power Restricted; T = Thermal ShutDown   Please, find this capture.   ... View more