Meraki Community

NickVardy76 · ‎Sep 23 2021

Thanks for the replies thus far. I am also right in saying that if you configure the Alternate Management IP address you are unable to browse to this Alternative Management IP. You can only use it for sending Radius, SNMP and Syslog messages?

NickVardy76 · ‎Sep 22 2021

Thanks for the reply. Shut all the ports? Can you then remotely managed the switches via the auto assigned IP via the Management port?

NickVardy76 · ‎Sep 22 2021

Hi to anyone that may be able to assist. I have a 4 stack Meraki 225-48FP all up and working. I am curious about the Management Port on the back of switch that you can use to log into the switch locally should the switch lose connectivity to the portal. Has anyone been able too or know if it is possible to use this port for Out of Band Management? ie log into the switch via this port following a loss of connectivity to the Meraki dashboard? It seems this port issues the same IP address on all switches so not sure if this possible? Just looking for some advise Many thanks in advance,

Meraki Community

About NickVardy76

NickVardy76

Community Record

Re: Management Port on back of MS225-48FP and Out of Band Management

Re: Management Port on back of MS225-48FP and Out of Band Management

Management Port on back of MS225-48FP and Out of Band Management