When I check the Organization -> Change Log after updating the L3 firewall rules, I noticed that there seems to be saved three properties for each rule which is not available in the Security & SD-WAN -> Firewall page.   These properties are VLAN, logging and enabled.   How can I access and utilize these properties, if possible? It would be nice to be able to temporary enable/disable rules by a checkbox, and also making rules per VLAN.   Here is a screenshot of one rule: ...and here is the corresponding record in the Change Log: {"Comment":"EVERYONE allow Teamviewer","Policy":"allow","Protocol":"any","Destination port":"Any","Destination IP":"*.teamviewer.com","Source port":"Any","Source IP":"Any","VLAN":"Any","logging":"false","enabled":"enabled"} ... View more

I have the below firewall rules. There exist a 192.168.33.0/24 network on a separate vlan. This network is only to be reached from 192.168.11.0/24, and should no be able to reach the Internet or anywhere else. While capturing packets on LAN, I still see packets to and replies from outside ip-addresses. No group policy applied to the network in question. What am I missing here?   I have tried to make a dedicated deny rule for source 192.168.33.0/24, and although the hit counter increments I still see outside packets when capturing.     ... View more